mfa August 26, 2021, 09:31:44 PM When I bought the car the mfa did not work. I have investigated and believe the display screen is shot I have sourced a replacement screen. Further to that I found the vacuum pipe disconnected I have not tried to connect it as the pipe looks to small a diameter the question is is there an adaptor between the two? The car is a 1990 with ce2 electrics.scs Last Edit: August 26, 2021, 09:40:54 PM by scs
Re: mfa Reply #1 – August 26, 2021, 10:57:43 PM You should have a rubber hose on the end or the more rigid plastic hose. Is yours missing?
Re: mfa Reply #2 – August 27, 2021, 09:28:17 AM the pipe is soft rubber hose and is quite pliable, there should be a barb on the back of the clocks and the pipe goes directly onto it.
Re: mfa Reply #3 – August 27, 2021, 10:25:10 AM Thanks the pipe does appear to be soft rubber just thought the diameter looked small compared to the ribbed mfa connection.scs
Re: mfa Reply #4 – August 27, 2021, 10:40:48 AM Should fit if it's all still original. The length can be a bit tricky, I have considered extending this but it's a bigger issue usually trying to get the speedo cable to snap on.
Re: mfa Reply #7 – August 27, 2021, 02:08:14 PM Quote from: Eddypeck on August 27, 2021, 01:26:43 PMthat's the geezer. annoyingly shortJust disconnect it in the engine bay (near the nrv) and then push the excess pipe back through the grommet.All the length you need then 1 Likes
Topic: mfa (Read 1150 times)
previous topic - next topic
